The conveyor belt manufacturer installs the conveyor belt to operate correctly

In the process of work, we will more or less encounter some problems. For example, today's conveyor belt manufacturers and everyone are talking about the correct way to install the conveyor belt.

In fact, when the conveyor belt manufacturer installs the conveyor belt, it only needs to correctly operate the following seven processes, and there is no problem.

①Put a rolling and flexible shaft on the conveyor belt take-up core, and set the belt roll up. Before putting it on the shelf, be careful not to reverse the direction of the upper and lower rubber covers.

②In the workplace where it is not suitable to be put on the shelf, the conveyor belt can be guided away, and the conveyor belt at the fold should have a large radius of curvature to avoid damage to the conveyor belt. The fold should prevent heavy objects from being placed on the conveyor belt.

③If it is to replace the conveyor belt, the new belt can be connected with the old belt, and the unloading can be carried out together with the new conveyor belt of the device.

④For horizontal conveyors, old conveyors can be blocked at any point. For conveyors working in an oblique direction, the blocking point must be selected to avoid losing control due to its own weight.

⑤After the conveyor has set the position of the new belt, fix one end of the tape with a clamp, and then connect it with the rope that goes around the roller and the pulley, and the conveyor belt is balanced on the conveyor by the traction device. When pulling, Avoid kneading the conveyor belt and the frame.

⑥Fix one end of the conveyor belt on the conveyor frame with a clamp, and the other end is tightened by a pulley until the conveyor belt does not sag significantly on the return roller.

⑦Fix the tensioning device 100~150mm away from the starting point.